Now showing 1 - 3 of 3
- PublicationTemperature effects on brain tissue in compressionExtensive research has been carried out for at least 50 years to understand the mechanical properties of brain tissue in order to understand the mechanisms of traumatic brain injury (TBI). The observed large variability in experimental results may be due to the inhomogeneous nature of brain tissue and to the broad range of test conditions. However, test temperature is also considered as one of the factors influencing the properties of brain tissue. In this research, the mechanical properties of porcine brain have been investigated at 22 °C (room temperature), and at 37 °C (body temperature) while maintaining a constant preservation temperature of approximately 4–5 °C. Unconfined compression tests were performed at dynamic strain rates of 30 and 50 s−1 using a custom made test apparatus. There was no significant difference (p=0.8559–0.9290) between the average engineering stresses of the brain tissue at the two different temperature conditions. The results of this study should help to understand the behavior of brain tissue at different temperature conditions, particularly in unconfined compression tests.
512Scopus© Citations 28
- PublicationMechanical characterization of brain tissue in compression at dynamic strain ratesTraumatic brain injury (TBI) occurs when local mechanical load exceeds certain tolerance levels for brain tissue. Extensive research has been done previously for brain matter experiencing compression at quasistatic loading; however, limited data is available to model TBI under dynamic impact conditions. In this research, an experimental setup was developed to perform unconfined compression tests and stress relaxation tests at strain rates ≤90/s. The brain tissue showed a stiffer response with increasing strain rates, showing that hyperelastic models are not adequate. Specifically, the compressive nominal stress at 30% strain was 8.83 ± 1.94, 12.8 ± 3.10 and 16.0 ± 1.41 kPa (mean ± SD) at strain rates of 30, 60 and 90/s, respectively. Relaxation tests were also conducted at 10%–50% strain with the average rise time of 10 ms, which can be used to derive time dependent parameters. Numerical simulations were performed using one-term Ogden model with initial shear modulus μo=6.06±1.44, 9.44 ± 2.427 and 12.64 ± 1.227 kPa (mean ± SD) at strain rates of 30, 60 and 90/s, respectively. A separate set of bonded and lubricated tests were also performed under the same test conditions to estimate the friction coefficient μ, by adopting combined experimental–computational approach. The values of μ were 0.1 ± 0.03 and 0.15 ± 0.07 (mean ± SD) at 30 and 90/s strain rates, respectively, indicating that pure slip conditions cannot be achieved in unconfined compression tests even under fully lubricated test conditions. The material parameters obtained in this study will help to develop biofidelic human brain finite element models, which can subsequently be used to predict brain injuries under impact conditions.
556Scopus© Citations 188
- PublicationInfluence of preservation temperature on the measured mechanical properties of brain tissueThe large variability in experimentally measured mechanical properties of brain tissue is due to many factors including heterogeneity, anisotropy, age dependence and post-mortem time. Moreover, differences in test protocols also influence these measured properties. This paper shows that the temperature at which porcine brain tissue is stored or preserved prior to testing has a significant effect on the mechanical properties of brain tissue, even when tests are conducted at the same temperatures. Three groups of brain tissue were stored separately for at least 1 h at three different preservation temperatures, i.e., ice cold, room temperature (22 °C) and body temperature (37 °C), prior to them all being tested at room temperature (∼22 °C). Significant differences in the corresponding initial elastic shear modulus μ (Pa) (at various amounts of shear, 0≤K≤1.0) were observed. The initial elastic moduli were 1043±271 Pa, 714±210 Pa and 497±156 Pa (mean±SD) at preservation temperatures of ice cold, 22 °C and 37 °C, respectively. Based on this investigation, it is strongly recommended that brain tissue samples must be preserved at an ice-cold temperature prior to testing in order to minimize the difference between the measured in vitro test results and the in vivo properties. A by-product of the study is that simple shear tests allow for large, almost perfectly homogeneous deformation of brain matter.
673Scopus© Citations 31