Now showing 1 - 2 of 2
  • Publication
    Liquid-phase 3D bioprinting of gelatin alginate hydrogels: influence of printing parameters on hydrogel line width and layer height
    (Springer Science and Business Media LLC, 2019-07-16) ; ; ; ;
    Extrusion-based 3D bioprinting is a direct deposition approach used to create three-dimensional (3D) tissue scaffolds typically comprising hydrogels. Hydrogels are hydrated polymer networks that are chemically or physically cross-linked. Often, 3D bioprinting is performed in air, despite the hydrated nature of hydrogels and the potential advantage of using a liquid phase to provide cross-linking and otherwise functionalize the hydrogel. In this work, we print gelatin alginate hydrogels directly into a cross-linking solution of calcium chloride and investigate the influence of nozzle diameter, distance between nozzle and surface, calcium chloride concentration, and extrusion rate on the dimensions of the printed hydrogel. The hydrogel layer height was generally found to increase with increasing extrusion rate and nozzle distance, according to the increased volume extruded and the available space, respectively. In addition, the hydrogel width was generally found to increase with decreasing nozzle distance and cross-linking concentration corresponding to confinement-induced spreading and low cross-linking regimes, respectively. Width/height ratios of ~ 1 were generally achieved when the nozzle diameter and distance were comparable above a certain cross-linking concentration. Using these relationships, biocompatible 3D multilayer structures were successfully printed directly into calcium chloride cross-linking solution.
      656Scopus© Citations 26
  • Publication
    3D-Printed Peptide-Hydrogel Nanoparticle Composites for Surface-Enhanced Raman Spectroscopy Sensing
    Precise control over the arrangement of plasmonic nanomaterials is critical for label-free single-molecule surface-enhanced Raman spectroscopy (SERS)-based sensing applications. SERS templates should provide high sensitivity and reproducibility and be cost-effective and easy to prepare. Additive manufacturing by extrusion-based three-dimensional (3D) printing is an emerging technique for the spatial arrangement of nanomaterials and is a method that may satisfy these SERS template requirements. In this work, we use 3D printing to produce sensitive and reproducible SERS templates using a fluorenylmethyloxycarbonyl diphenylalanine (Fmoc-FF) hydrogel loaded with silver or gold nanoparticles. The Fmoc-FF template allows the detection of low Raman cross-section molecules such as adenine at concentrations as low as 100 pM.
      625Scopus© Citations 22